4-41
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 4 Security Setup
Setting Up Administrator Authorization
• Firmware—The user can update the access point's firmware. When you
assign Firmware capability to a user, the user also automatically receives
Write and Admin capabilities.
• Admin—The user can view most system screens. To allow the user to view
all system screens and make changes to the system, select Write capability.
Step 6 Click Apply. The User Management window disappears, and the new user appears
in the user list on the User Information page.
Step 7 Click the browser’s Back button to return to the Security Setup page. On the
Security Setup page, click User Manager. The User Manager Setup page appears.
Figure 4-17 shows the User Manager Setup page.
Figure 4-17 User Manager Setup Page
Step 8
Select User Manager: Enabled to restrict use of the access point management
system to users in the user list.
Note You must define a full administrator user—a user with write, identity, and
firmware capabilities—before you can enable the user manager.
Use the other settings on the User Manager Setup page to add more restrictions
for the management system:
• Allow Read-Only Browsing without Login—Select yes to allow any user to
view the access point’s basic screens. Select no to restrict access to all of the
access point’s screens to only the users in the user list.
To Next Page
Loading...
