Cisco ASR 1000 Series Configuration Guide

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ipv6 wccp [vrf vrf-name] {web-cache | service-number} [group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password password]
4.
ipv6 wccp check acl outbound
5.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables support for a Cisco content engine service group
or any content engine service group and configures a
redirect ACL list or group ACL.
ipv6 wccp [vrf vrf-name] {web-cache | service-number}
[group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password password]
Example:
Device(config)# ipv6 wccp web-cache
Step 3
Checks the access control list (ACL) for egress interfaces
for packets redirected by WCCP.
ipv6 wccp check acl outbound
Example:
Device(config)# ipv6 wccp check acl outbound
Step 4
Exits global configuration.exit
Example:
Device(config)# exit
Step 5
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
109
WCCPv2—IPv6 Support
Enabling the WCCP—IPv6 Outbound ACL Check

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model