Cisco ASR 1000 Series

Configuration Examples for WCCPv2—IPv6 Support
Example: Configuring a General WCCPv2—IPv6 Session
Device# configure terminal
Device(config)# ipv6 wccp web-cache password password1
Device(config)# ipv6 wccp source-interface GigabitEthernet 0/1/0
Device(config)# ipv6 wccp check services all
Configures a check of all WCCP services.
Device(config)# interface GigabitEthernet 0/1/0
Device(config-if)# ipv6 wccp web-cache redirect in
Device(config-if)# exit
Device(config)# interface GigabitEthernet 0/2/0
Device(config-if)# ipv6 wccp redirect exclude in
Device(config-if)# exit
Example: WCCPv2—IPv6—Setting a Password for a Router and Content
Engines
Device# configure terminal
Device(config)# ipv6 wccp web-cache password password1
Example: WCCPv2—IPv6—Configuring a Web Cache Service
Device# configure terminal
Device(config)# ipv6 wccp web-cache
Device(config)# interface GigabitEthernet 0/1/0
Device(config-if)# ipv6 wccp web-cache redirect in
Device(config-if)# exit
Device# copy running-config startup-config
The following example shows how to configure a session in which redirection of HTTP traffic arriving on
Gigabit Ethernet interface 0/1/0 is enabled:
Device# configure terminal
Device(config)# interface GigabitEthernet 0/1/0
Device(config-if)# ipv6 wccp web-cache redirect in
Device(config-if)# exit
Device# show ip interface GigabitEthernet 0/1/0
.
.
.
WCCP Redirect inbound is enabled
WCCP Redirect exclude is disabled
.
.
.
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
111
WCCPv2—IPv6 Support
Configuration Examples for WCCPv2—IPv6 Support