EasyManuals Logo

Cisco ASR 1000 Series Configuration Guide

Cisco ASR 1000 Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
PurposeCommand or Action
Example:
Device(config)# ipv6 wccp 99 group-address
FF15::8000:1
Enables the interfaces to which the content engines will
connect to receive multicast transmissions for which the
interface type number
Example:
Device(config)# interface ethernet 0/0
Step 5
web cache service will run, and enters interface
configuration mode.
(Optional) Enables Protocol Independent Multicast (PIM)
on an interface.
ip pim {sparse-mode | sparse-dense-mode | dense-mode
[proxy-register {list access-list | route-map
map-name}]}
Step 6
To ensure correct operation of the ipv6 wccp
group-listen command, you must enter the ip pim
command in addition to the ipv6 wccp
group-listen command.
Note
Example:
Device(config-if)# ip pim dense-mode
Configures an interface to enable or disable the reception
of IP multicast packets for WCCP.
ipv6 wccp [vrf vrf-name] {web-cache | service-number}
group-listen
Example:
Device(config-if)# ipv6 wccp 99 group-listen
Step 7
Using Access Lists for WCCPv2IPv6 Service Group
Perform this task to configure the router to use an access list to determine which traffic should be directed to
which content engines.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
access-list access-list-number remark remark
4.
access-list access-list-number permit {source [source-wildcard] | any} [log]
5.
access-list access-list-number remark remark
6.
access-list access-list-number deny {source [source-wildcard] | any} [log]
7.
Repeat some combination of Steps 3 through 6 until you have specified the sources on which you want
to base your access list.
8.
ipv6 wccp [vrf vrf-name] web-cache group-list access-list
9.
ipv6 wccp [vrf vrf-name] web-cache redirect-list access-list
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
106
WCCPv2IPv6 Support
Using Access Lists for WCCPv2IPv6 Service Group

Table of Contents

Other manuals for Cisco ASR 1000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1000 Series and is the answer not in the manual?

Cisco ASR 1000 Series Specifications

General IconGeneral
SeriesASR 1000
CategoryNetwork Router
Operating SystemCisco IOS XE
MemoryUp to 64 GB
Interfaces10 Gigabit Ethernet
Power SupplyAC or DC options
DimensionsVaries by model
EncryptionIPsec, SSL
StorageVaries by model
Operating Temperature32°F to 104°F (0°C to 40°C)
Humidity5% to 95% non-condensing
MTBFVaries by model

Related product manuals