Cisco ASR 1000 Series - Page 80

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip wccp [vrf vrf-name] {web-cache | service-number} [group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password password]
4.
ip wccp check acl outbound
5.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables the support for a Cisco content engine service group
or any content engine service group and configures a redirect
ACL list or group ACL.
ip wccp [vrf vrf-name] {web-cache | service-number}
[group-address multicast-address] [redirect-list
access-list] [group-list access-list] [password
password]
Step 3
The web-cache keyword is for WCCP version 1 and
version 2 and the service-number argument is for
WCCP version 2 only.
Note
Example:
Device(config)# ip wccp web-cache
Checks the access control list (ACL) for egress interfaces for
packets redirected by WCCP.
ip wccp check acl outbound
Example:
Device(config)# ip wccp check acl outbound
Step 4
Exits global configuration.exit
Example:
Device(config)# exit
Step 5
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
72
Configuring WCCP
Enabling the WCCP Outbound ACL Check