Cisco ASR 1001-X Installation Guide

x
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-03
Audience
This publication is primarily designed for persons responsible for installing, maintaining, and
troubleshooting the Cisco ASR 1001-X Router. The users of this guide should:
• Be familiar with electronic circuitry and wiring practices.
• Have experience working as electronic or electromechanical technicians.
• Have experience in installing high-end networking equipment.
Note Certain procedures described in this guide require a certified electrician.
Document Organization
The following table describes the chapters and appendixes in this installation guide:
Chapter and Appendix Description
Chapter 1, “Cisco ASR 1001-X Router Overview” This chapter provides an overview of the Cisco
ASR 1001-X Router.
Chapter 2, “Cisco ASR 1001-X Router Supported Hardware
Components”
This chapter provides an overview of the hardware
components for the Cisco ASR 1001-X Router.
Chapter 3, “Preparing Your Site for Installation” This chapter provides site preparation guidelines for
installing the Cisco ASR 1001-X Router.
Chapter 4, “Cisco ASR 1001-X Router Installation” This chapter provides information about the installation
methods and steps to install the Cisco ASR 1001-X
Router.
Chapter 5, “Cisco ASR 1001-X Router Power Up and Initial
Configuration”
This chapter provides basic system startup and initial
configuration information.
Chapter 6, “Cisco ASR 1001-X Router License Verification” This chapter provides information about the Cisco ASR
1001-X Router licenses.
Chapter 7, “Removing and Replacing FRUs from the Cisco ASR
1001-X Router”
This chapter provides instructions for removing and
replacing the various FRUs in the Cisco ASR 1001-X
Router.
Chapter 8, “Upgrading the ROMMON and CPLD” This chapter describes the procedures to upgrade the
ROMmon on the Cisco ASR 1001-X Router.
Appendix A, “Cisco ASR 1001-X Router Specifications” This appendix provides router specifications for the
Cisco ASR 1001-X Router.
Appendix B, “Cisco ASR 1001-X Router Signals and Pinouts” This appendix lists pinout specifications for the Cisco
ASR 1001-X Router.

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g