Cisco Catalyst 4500e Series - Page 149

Index
IN-3
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
description D-4
Ethernet management ports
LEDs 5-3
network switching not supported (note) D-4
troubleshooting 5-3
F
FAIL LEDs
checking 4-7
verifying power supply status 4-13
fan assemblies
booting 5-2
Catalyst 4503-E switches (figure) 1-3
Catalyst 4506-E switches (figure) 1-6
Catalyst 4507 switches (figure) 1-10, 1-14
description 1-24
installing 4-14
power supplies 1-28
removing 4-13
replacing 4-13
troubleshooting 5-6
verifying installation 4-15
FAN OK LED
checking 4-7
description 1-28
Fast Ethernet
See 100BASE-T
field-replaceable units
See FRUs
Flash code
troubleshooting 5-3
front panel components D-3
FRUs
AC-input power supplies 4-4 to 4-8
DC-input power supplies 4-8 to 4-13
fan assemblies 4-13 to 4-15
G
Gigabit Ethernet
See 1000BASE-T
See 1000BASE-X
GOOD LEDs
checking 4-7
troubleshooting 5-4
verifying power supply status 4-13
grounding
connecting systems 3-6
ground wire
figure 4-10
H
heat dissipation
description (table) 2-3
supervisor engines 2-3
switch chassis 2-3
switching modules 2-3
help
See TAC
hot swapping
fan assemblies 4-13
status messages D-8
switching modules D-8
humidity
Catalyst 4503-E switch specifications (table) A-1
Catalyst 4506-E switch specifications (table) A-2
Catalyst 4507 switch specifications (table) A-3, A-5
I
INPUT OK LED
description (table) 1-28
installation
connecting to a power source C-2
starting the terminal-emulation software C-2