Cisco Catalyst 4500e Series User Manual

4-10
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
Chapter 4 Removing and Replacing FRUs
Removing and Replacing the Power Supply
Figure 4-13 Connecting the DC-Input Wires
Figure 4-14 Connecting the DC-Input Wires (Triple-input Power Supply)
Step 6 Using a screwdriver, loosen and remove the captive screws on the power supply. (See Figure 4-15, which
shows the single input power supply. The triple-input power supply has captive screws in the same
location.)
Figure 4-15 Loosening the Captive Screws
RS-485 serial
communnication
connector
79161
Grounding lug
Grounding lug nuts
DC-input wires
Negative
Positive
Ground
231892
1
-
+
-
+
-
+
2
3
Grounding lugs (2)
Grounding lug nut
DC-input wires
Negative
Positive
Ground
Captive screws
79162

Cisco Catalyst 4500e Series Specifications

General

Series	Catalyst 4500E Series
Stackable	No
Chassis Options	3-slot, 6-slot, 7-slot, 10-slot
Power Supply Options	AC, DC
Redundancy	Power supply redundancy, supervisor engine redundancy (1+1)
Layer Support	Layer 2
Virtualization	Yes (Virtual Switching System - VSS)
Form Factor	Modular
Ports	Gigabit Ethernet, 10 Gigabit Ethernet, 40 Gigabit Ethernet, and 100 Gigabit Ethernet options depending on the line cards
Jumbo Frame Support	Yes
Features	Flexible NetFlow, TrustSec
Maximum Port Density	Up to 384 ports per chassis
Operating System	Cisco IOS XE
Management	CLI, SNMP, Cisco Prime Infrastructure, Cisco DNA Center
Security Features	802.1X
VLAN Support	Up to 4096 VLANs
QoS Support	Yes
Supervisor Engine Options	Sup8-E