Cisco Catalyst 9300X User Manual

DescriptionSupported Power Supply ModulesSwitch Series
350 W AC Platinum certified power supply
module
PWR-C1-350WAC-PC9300X Series
Switches
715 W AC Platinum certified power supply
module
PWR-C1-715WAC-P
1100 W AC Platinum certified power supply
module
PWR-C1-1100WAC-P
1900 W AC Platinum certified power supply
module
PWR-C1-1900WAC-P
1. PWR-C1-1900WAC-P provides 1900 W output power when the nominal input voltage is 230 V. If the
nominal input voltage is 115 V, then the output power is limited to 1500 W. See Table 47: AC Power
Cords for PWR-C1-1900WAC-P, on page 119 for suitable power cord options.
For more information about power supplies, see Specifications for the Power Supplies, Switches, and
Fan, on page 116.
Note
For information on available PoE, PoE+, and Cisco UPOE/UPOE+ requirements, see these sections the Power
Supply Modules, on page 25.
The 350 W and 715 W AC power supply modules are autoranging units that support input voltages from 100
through 240 VAC. The 1100W power supply module is an autoranging unit that supports input voltages from
115 through 240 VAC.
Each AC power supply module has a power cord for connection to an AC power outlet. To view the list of
available AC power cords, see AC Power Cord Specifications, on page 118.
The following illustrations show the power supply modules.
Figure 46: 1100 W AC Power Supply
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
83
Installing a Power Supply
Power Supply Modules Overview

Cisco Catalyst 9300X Specifications

General

Category	Switch
Total number of MAC addresses	64, 000
Total number of IPv4 routes	32, 000
Total number of IPv6 routes	16, 000
Jumbo frames	9198 bytes
DRAM	8 GB
Flash	16 GB
Model	Cisco Catalyst 9300X
Number of VLANs	4, 094
Operating Temperature	32°F to 104°F (0°C to 40°C)
Operating Humidity	5 to 90% relative humidity