Cisco Catalyst C9200-48T User Manual

Figure 43: Site Profile - Distribution Switches
Figure 44: Site Profile - Distribution Switches (with Routed Access)
Table 14: Default Configuration Loaded with Each Site Profile (Core Switches)
Standalone Collapsed Core Switch
(with ECMP Peer and Port Channel
Downlink)
Standalone Core Switch (with
ECMP Peers)
Setting
The hostname or device name you
provided as part of Quick Setup
The hostname or device name you
provided as part of Quick Setup
Hostname
EnabledEnabledUDLD
Recovery mode set to AutoRecovery mode set to AutoError Disable Recovery
Source Destination IPSource Destination IPPort Channel Load Balance
Version 2Version 2SSH
EnabledEnabledSCP
EnabledEnabledVTY Access to Switch
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
63
Configuring the Switch
Configuring Your Device Based on a Site Profile

Cisco Catalyst C9200-48T Specifications

General

Total 10/100/1000 or Multigigabit copper ports	48 x 10/100/1000
Switching Capacity	176 Gbps
DRAM	4 GB
Flash	16 GB
PoE Support	No
MTBF	1, 000, 000 hours
Power Device	Internal power supply
Rack Mountable	Yes
Product Type	Layer 3 Switch
Uplink Ports	4 x 10 Gigabit Ethernet
Input Voltage	AC 120/230 V
Authentication Method	Secure Shell (SSH), RADIUS, TACACS+
Operating Temperature	0 to 45°C