Cisco Catalyst C9200-48T User Manual

Standalone Collapsed Core Switch
(with ECMP Peer and Port Channel
Downlink)
Standalone Core Switch (with
ECMP Peers)
Setting
Unicast RPF (uRPF) in strict modeUnicast RPF (uRPF) in strict modeMitigate Address Spoofing
EnabledEnabledService Timestamp
Layer 3 settings configured on the
management port, based on Quick
Setup
Layer 3 settings configured on the
management port, based on Quick
Setup
Management Interface
QoS Policy for Distribution/Core
defined
QoS Policy for Distribution/Core
defined
QoS Policy
Selected uplink ports connect to
MAN/WAN device
Selected uplink ports connect to
MAN/WAN device
Uplink Interfaces
Downlink connections to
distribution switches
Downlink connections to access
switches
Downlink Interfaces
Selected ports connect to other core
switches
Selected ports connect to other core
switches
Cross-connect Interfaces
Figure 45: Site Profile - Core Switches
Configuring Switch Wide Settings
Configuring VLAN Settings
Procedure
Step 1 In the VLAN Configuration section, you can configure both data and voice VLANs. Type a name for your
data VLAN.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
64
Configuring the Switch
Configuring Switch Wide Settings

Cisco Catalyst C9200-48T Specifications

General

Total 10/100/1000 or Multigigabit copper ports	48 x 10/100/1000
Switching Capacity	176 Gbps
DRAM	4 GB
Flash	16 GB
PoE Support	No
MTBF	1, 000, 000 hours
Power Device	Internal power supply
Rack Mountable	Yes
Product Type	Layer 3 Switch
Uplink Ports	4 x 10 Gigabit Ethernet
Input Voltage	AC 120/230 V
Authentication Method	Secure Shell (SSH), RADIUS, TACACS+
Operating Temperature	0 to 45°C