Cisco Catalyst C9200-48T User Manual

Figure 48: Port Settings
What to do next
• Click Day 0 Config Summary to verify your setup.
• Click Finish.
Figure 49: Day 0 Config Summary
Configuring VTY Lines
For connecting to the device through Telnet or SSH, the Virtual Terminal Lines or Virtual TeleType (VTY)
is used. The number of VTY lines is the maximum number of simultaneous access to the device remotely. If
the device is not configured with sufficient number of VTY lines, users might face issues with connecting to
the WebUI. You must change the default value for VTY Line, 0-15 (or 0-4 in some models), to 0-30 to allow
up to thirty simultaneous sessions.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
67
Configuring the Switch
Configuring VTY Lines

Cisco Catalyst C9200-48T Specifications

General

Total 10/100/1000 or Multigigabit copper ports	48 x 10/100/1000
Switching Capacity	176 Gbps
DRAM	4 GB
Flash	16 GB
PoE Support	No
MTBF	1, 000, 000 hours
Power Device	Internal power supply
Rack Mountable	Yes
Product Type	Layer 3 Switch
Uplink Ports	4 x 10 Gigabit Ethernet
Input Voltage	AC 120/230 V
Authentication Method	Secure Shell (SSH), RADIUS, TACACS+
Operating Temperature	0 to 45°C