EasyManuals Logo

Cisco Catalyst C9200-48T User Manual

Cisco Catalyst C9200-48T
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
Figure 40: Basic Settings - Device Management Settings
Configuring Your Device Based on a Site Profile
To ease your configuration tasks and save time, choose a site profile based on where your device may be
installed and managed in your network. Based on the site profile you choose, your device is automatically
configured according to Cisco best practices. You can easily modify this default configuration, from the
corresponding detailed configuration screens.
Choosing a site profile as part of Quick Setup allows you to configure your device based on the business needs
of your enterprise. For example, you could use your device as an access switch, to connect client nodes and
endpoints on your network, or as a distribution switch, to route packets between subnets and VLANs.
Table 12: Default Configuration Loaded with Each Site Profile (Access Switches)
Single Access Switch
(Redundant Port Channel
Uplink)
Single Access Switch
(Single Port Channel
Uplink)
Single Access Switch
(Single Uplink)
Setting
The hostname or device
name you provided as part
of Quick Setup
The hostname or device
name you provided as part
of Quick Setup
The hostname or device
name you provided as part
of Quick Setup
Hostname
RPVST+RPVST+RPVST+Spanning Tree Mode
Mode TransparentMode TransparentMode TransparentVTP
EnabledEnabledEnabledUDLD
Recovery mode set to
Auto
Recovery mode set to
Auto
Recovery mode set to
Auto
Error Disable Recovery
Source Destination IPSource Destination IPSource Destination IPPort Channel Load
Balance
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
59
Configuring the Switch
Configuring Your Device Based on a Site Profile

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst C9200-48T and is the answer not in the manual?

Cisco Catalyst C9200-48T Specifications

General IconGeneral
Total 10/100/1000 or Multigigabit copper ports48 x 10/100/1000
Switching Capacity176 Gbps
DRAM4 GB
Flash16 GB
PoE SupportNo
MTBF1, 000, 000 hours
Power DeviceInternal power supply
Rack MountableYes
Product TypeLayer 3 Switch
Uplink Ports4 x 10 Gigabit Ethernet
Input VoltageAC 120/230 V
Authentication MethodSecure Shell (SSH), RADIUS, TACACS+
Operating Temperature0 to 45°C

Related product manuals