Cisco Catalyst C9200-48T User Manual

Single Access Switch
(Redundant Port Channel
Uplink)
Single Access Switch
(Single Port Channel
Uplink)
Single Access Switch
(Single Uplink)
Setting
Version 2Version 2Version 2SSH
EnabledEnabledEnabledSCP
EnabledEnabledEnabledVTY Access to Switch
EnabledEnabledEnabledService Timestamp
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
VLAN
Layer 3 settings
configured on the
management port, based
on Quick Setup
Layer 3 settings
configured on the
management port, based
on Quick Setup
Layer 3 settings
configured on the
management port, based
on Quick Setup
Management Interface
IPv6 host policy createdIPv6 host policy createdIPv6 host policy createdIPv6 Host Policy
Auto QoS Policy for
Access defined
Auto QoS Policy for
Access defined
Auto QoS Policy for
Access defined
QoS Policy for Downlink
Ports
QoS Policy for
Distribution created
QoS Policy for
Distribution created
QoS Policy for
Distribution created
QoS Policy for Uplink
Ports
Selected ports configured
as Port-channel in trunk
mode, set to allow all
VLANs.
Selected ports configured
as Port-channel in trunk
mode, set to allow all
VLANs.
Selected uplink interfaces
configured as trunk ports,
set to allow all VLANs
Uplink Interfaces
Downlink ports
configured in Access
mode
Downlink ports
configured in Access
mode
Downlink ports
configured in Access
mode
Downlink Interfaces
Port-channel to
distribution created
Port-channel to
distribution created
Not configuredPort-channel
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
60
Configuring the Switch
Configuring Your Device Based on a Site Profile

Cisco Catalyst C9200-48T Specifications

General

Total 10/100/1000 or Multigigabit copper ports	48 x 10/100/1000
Switching Capacity	176 Gbps
DRAM	4 GB
Flash	16 GB
PoE Support	No
MTBF	1, 000, 000 hours
Power Device	Internal power supply
Rack Mountable	Yes
Product Type	Layer 3 Switch
Uplink Ports	4 x 10 Gigabit Ethernet
Input Voltage	AC 120/230 V
Authentication Method	Secure Shell (SSH), RADIUS, TACACS+
Operating Temperature	0 to 45°C