Creating User Accounts
Setting a username and password is the first task you will perform on your device. Typically, as a network
administrator, you will want to control access to your device and prevent unauthorized users from seeing your
network configuration or manipulating your settings.
Procedure
Step 1 Log on using the default username and password provided with the device. These details differ based on the
software version of your switch.
The default username is cisco; the default password is the serial number of the switch chassis. For Cisco
Catalyst switches running software versions earlier than Cisco IOS XE Fuji 16.9.x, the default username is
webui; the default password is the serial number of the switch chassis.
Step 2 Set a password of up to 25 alphanumeric characters. The username password combination you set gives you
privilege 15 access. The string cannot start with a number, is case sensitive, and allows spaces but ignores
leading spaces.
Figure 38: Create Account
Choosing Setup Options
Select Wired Network to configure your device based on a site profile, and continue to configure switch
wide settings. Otherwise, continue to the next step and configure only basic settings for your device.
Configuring Basic Device Settings
On the Basic Device Settings page configure the following information:
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
57
Configuring the Switch
Creating User Accounts
To Next Page
Loading...
Need help?
General
