EasyManuals Logo

Cisco Catalyst C9200L-24PXG-4X-E Hardware Installation Guide

Cisco Catalyst C9200L-24PXG-4X-E
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
CHAPTER 5
Installing a Network Module
Installing a Network Module in the Switch, on page 77
Removing a Network Module, on page 81
Finding the Network Module Serial Number, on page 82
Installing and Removing Pluggable Transceiver Modules, on page 83
Installing a Network Module in the Switch
Safety Warnings
This section includes the installation cautions and warnings. Translations of the safety warnings are available
in the Regulatory Compliance and Safety Information for Cisco Catalyst 9200 Series Switches .
Read this section before you install a network module.
Proper ESD protection is required whenever you handle equipment. Installation and maintenance
personnel should be properly grounded by grounding straps to eliminate the risk of ESD damage to the
equipment. Equipment is subject to ESD damage whenever you remove it.
Caution
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could
constitute an energy hazard. Statement 206
Warning
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
77

Table of Contents

Other manuals for Cisco Catalyst C9200L-24PXG-4X-E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst C9200L-24PXG-4X-E and is the answer not in the manual?

Cisco Catalyst C9200L-24PXG-4X-E Specifications

General IconGeneral
BrandCisco
ModelCatalyst C9200L-24PXG-4X-E
CategorySwitch
LanguageEnglish

Related product manuals