PurposeCommand or Action
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
bsr candidate-bsr 10.0.0.1 hash-mask-len 30
Configures the router to advertise itself as a PIM Version
2 candidate RP to the BSR.
bsr candidate-rp ip-address [group-list access-list
interval seconds] [priority value] bidir
Step 4
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
•
See Step 9, on page 95 for group list 4
configuration.
bsr candidate-rp 172.16.0.0 group-list 4 bidir
(Optional) Enters interface configuration mode for the
PIM protocol.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
Step 5
interface GigE 0/1/0/0
(Optional) Stops the forwarding of bootstrap router (BSR)
messages on a Protocol Independent Multicast (PIM)
router interface.
bsr-border
Example:
RP/0/RP0/CPU0:router(config-pim-ipv4-if)#
bsr-border
Step 6
(Optional) Exits PIM interface configuration mode, and
returns the router to PIM configuration mode.
exit
Example:
RP/0/RP0/CPU0:router(config-pim-ipv4-if)# exit
Step 7
Exits PIM configuration mode.exit
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
Step 8
exit
(Optional) Defines the candidate group list to the BSR.
{ipv4 | ipv6} access-list name
Step 9
Example:
RP/0/RP0/CPU0:router(config)# ipv4 access-list 4
•
Access list number 4 specifies the group prefix
associated with the candidate RP address 172.16.0.0.
(See Step 4, on page 95).
•
This RP is responsible for the groups with the prefix
239.
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
95
Implementing Multicast Routing on Cisco IOS XR Software
Configuring the Bootstrap Router
To Next Page
Loading...
Need help?
General
