Cisco CRS Series - Configuring MVPN MLDP BIDIR

PurposeCommand or Action
Configures the Rendezvous point and assigns an RP
to multicast groups.
rp-address ip-address
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
Step 49
The RP mechanism can be static, auto-rp,
or BSR.
Note
rp-address 10.10.10.10
Configures the VRF.
vrf name
Example:
RP/0/RP0/CPU0:router(config-bgp)# vrf vrf1
Step 50
Configures ipv4 address-family for mvpn and enters
the address family command mode.
address-family {ipv4 | ipv6}
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
Step 51
address-family ipv4
Configures the Rendezvous point and assigns an RP
to multicast groups.
rp-address ip-address [group-access-list] [bidir]
Example:
RP/0/RP0/CPU0:router(config-pim-default-ipv4)#
Step 52
rp-address 101.101.101.101 group_1 bidir
commit
Step 53
Configuring MVPN MLDP BIDIR
Perform these steps to configure MVPN MLDP BIDIR.
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
83
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR