Cisco CRS Series - Configuring the Mldp User Interface for Feature Filtering - Make-Before-Break

PurposeCommand or Action
An example output is as shown:
Wed Jun 25 12:46:52.177 IST
Use the show command to verify the configuration:
show running-config mpls ldp mldp
Step 6
mpls ldp
mldp
address-family ipv4
make-before-break delay 0
mofrr route-policy mldp_policy
neighbor route-policy mldp_policy out
neighbor 1.1.1.1 route-policy mldp_policy in
neighbor 1.1.1.1 route-policy mldp_policy out
neighbor 2.2.2.2 route-policy mldp_policy out
recursive-fec route-policy mldp_policy
!
!
!
An example output showing the mLDP MoFRR output
RP/0/1/CPU0:GSR3#sh mpls mldp database opaquetype ipv4
mLDP database
LSM-ID: 0x00019 Type: P2MP Uptime: 03:25:15
FEC Root : 10.0.0.1
Opaque decoded : [ipv4 0.0.0.0 224.1.1.1]
Features : MoFRR
Upstream neighbor(s) :
10.0.0.1:0 [Active] Uptime: 03:25:15
Next Hop : 10.0.3.3
Interface : GigabitEthernet0/2/1/1
Local Label (D) : 16028
Downstream client(s):
LDP 10.0.0.2:0 Uptime: 03:25:15
Next Hop : 10.0.4.2
Interface : GigabitEthernet0/2/1/2
Remote label (D) : 16029
Configuring the mLDP User Interface for Feature Filtering - Make-before-break
SUMMARY STEPS
1.
configure
2.
mpls ldp mldp
3.
address-family ipv4
4.
make-before-break route-policy mldp_policy
5.
end
6.
commit
7.
Use the show command to verify the configuration: show running-config mpls ldp mldp
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
56
Implementing Multicast Routing on Cisco IOS XR Software
Multipoint Label Distribution Protocol Route Policy Map