Cisco CRS Series - Configuration Examples for P2 MP-TE Profiles

address-family ipv4
mdt mtu 1600
mdt mldp in-band-signaling ipv4
interface all enable
!
address-family ipv6
mdt mtu 1600
mdt mldp in-band-signaling ipv4
interface all enable
!
!
router pim
vrf v61
address-family ipv4
rpf topology route-policy mldp-inband
!
address-family ipv6
rpf topology route-policy mldp-inband
!
!
route-policy mldp-inband
set core-tree mldp-inband
end-policy
!
Profile-7: Global Inband mLDP
multicast-routing
address-family ipv4
mdt source Loopback0
mdt mldp in-band-signaling ipv4
ssm range Global-SSM-Group
interface all enable
!
address-family ipv6
mdt source Loopback0
mdt mldp in-band-signaling ipv4
ssm range Global-SSM-Group-V6
interface all enable
!
router pim
address-family ipv4
rpf topology route-policy mldp-inband
!
address-family ipv6
rpf topology route-policy mldp-inband
!
!
route-policy mldp-inband
set core-tree mldp-inband
end-policy
!
Configuration Examples for P2MP-TE profiles
Profile-8: Global Static P2MP-TE
interface Loopback0
ipv4 address 200.200.1.1 255.255.255.255
!
multicast-routing
address-family ipv4
mdt source Loopback0
ssm range Global-SSM-Group
interface all enable
!
address-family ipv6
mdt source Loopback0
ssm range Global-SSM-Group-V6
interface all enable
!
router igmp
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
149
Implementing Multicast Routing on Cisco IOS XR Software
Configuration Examples for MVPN Profiles