Cisco CRS Series - P2 MP Configurations at Egress Node and Bud Node; Configuring Static Reverse Path Forwarding (RPF)

PurposeCommand or Action
interface tunnel-mte 100
If enable is set, MFIB forwards multicast packets
over the interface. If disable is set, MFIB stops
forwarding multicast packets over the interface.
enable | disable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 5
enable
commit
Step 6
P2MP configurations at egress node and bud node
Configuring Static Reverse Path Forwarding (RPF)
SUMMARY STEPS
1.
configure
2.
multicast-routing
3.
address-family {ipv4 | ipv6}
4.
static-rpf address range prefix
5.
mpls address
6.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters multicast routing configuration mode.multicast-routing
Example:
RP/0/RP0/CPU0:router(config)# multicast-routing
Step 2
Enters ipv4 (or ipv6) address-family submode.address-family {ipv4 | ipv6}
Example:
RP/0/RP0/CPU0:router(config-mcast)# address-family
Step 3
ipv4
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
133
Implementing Multicast Routing on Cisco IOS XR Software
P2MP configurations at egress node and bud node