Cisco CRS Series - Multicast Nonstop Forwarding

PurposeCommand or Action
neighbor 1.1.1.1 route-policy mldp_policy
in
!
Configuring the mLDP User Interface for Feature Filtering
RPL policy allows the user to selectively enable features for filtering.
Configuring the mLDP User Interface for Feature Filtering - MoFRR
SUMMARY STEPS
1.
configure
2.
mpls ldp mldp
3.
mofrr route-policy mldp_policy
4.
end
5.
commit
6.
Use the show command to verify the configuration: show running-config mpls ldp mldp
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters the LDP configuration mode.mpls ldp mldp
Example:
RP/0/RP0/CPU0:router(config)#mpls ldp mldp
Step 2
Configures the specified feature to the MLDP policy to be
allowed to be selected for filtering.
mofrr route-policy mldp_policy
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)# mofrr
route-policy mldp_policy
Step 3
end
Step 4
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)# end
commit
Step 5
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
55
Implementing Multicast Routing on Cisco IOS XR Software
Multipoint Label Distribution Protocol Route Policy Map