Cisco CRS Series User Manual

PurposeCommand or Action
end-policy
Step 5
Example:
RP/0/RP0/CPU0:router(config-rpl)# end-policy
commit
Step 6
An example output is as shown:
Sun Jun 22 20:03:34.308 IST
Use the show command to verify the configuration: show
running-config route-policy mldp_policy
Step 7
route-policy mldp_policy
if mldp opaque vpnv6 2:2 10::1 ff05::1 then
pass
endif
end-policy
!
Configuring mLDP FEC at the Root Node
Perform this task to configure mLDP FEC at the root node using the route policy to filter Label Mappings
and selectively apply the configuration features. Currently, mLDP FEC is configured to filter at the IPV4 root
node address along with the mLDP opaque types.
Configuring the mLDP FEC at the Root Node Using the Route Policy
SUMMARY STEPS
1.
configure
2.
route-policy mldp_policy
3.
if mldp root
4.
end-policy
5.
commit
6.
Use the show command to verify the configuration: show running-config route-policy mldp_policy
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
52
Implementing Multicast Routing on Cisco IOS XR Software
Multipoint Label Distribution Protocol Route Policy Map

Cisco CRS Series Specifications

General

Category	Network Router
Operating System	Cisco IOS XR
Form Factor	Modular chassis
Routing Capacity	Up to 322 Tbps
Interface Support	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
Maximum Throughput	Up to 322 Tbps
Line Card Slots	4, 8, 16
Dimensions	Varies by chassis
Weight	Varies by chassis
Model	Cisco CRS Series