Cisco CRS Series - Page 94

SUMMARY STEPS
1.
configure
2.
interface type interface-path-id
3.
service-policy inputpolicy_name
4.
vrf vrf_name
5.
{ipv4 | ipv6} address address mask
6.
dot1q vlan value
7.
Repeat steps 6 to 37 of the Configuring MVPN BIDIR.
8.
mpls ldp
9.
router-id ipaddress
10.
mldp
11.
interface type interface-path-id
12.
multicast-routing [address-family {ipv4 | ipv6}]
13.
interface type interface-path-id enable
14.
nsf
15.
mdt source interface-path-id
16.
interface all enable
17.
vrf vrf_name
18.
address-family {ipv4 | ipv6}
19.
interface type interface-path-id
20.
enable
21.
interface type interface-path-id
22.
enable
23.
bgp auto-discovery mldp
24.
mdt source interface-path-id
25.
mdt mtu value
26.
mdt partitioned mldp {ipv4 | ipv6} mp2mp bidir
27.
interface all enable
28.
interface type interface-path-id
29.
enable
30.
bgp auto-discovery mldp
31.
mdt partitioned mldp {ipv4 | ipv6} mp2mp bidir
32.
interface all enable
33.
interface type interface-path-id
34.
description line
35.
vrf vrf_name
36.
{ipv4 | ipv6} address address mask
37.
router pim [address-family {ipv4 | ipv6}]
38.
rp-address ip-address
39.
vrf vrf_name
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
84
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR