Cisco CRS Series - Page 95

40.
address-family {ipv4 | ipv6}
41.
rpf topology route-policy policy_name
42.
rp-address ip-address [group-access-list] [bidir]
43.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
Step 2
GigabitEthernet0/3/0/1.7
Configures a service-policy in the input direction.
service-policy inputpolicy_name
Example:
RP/0/RP0/CPU0:router(config-if)# service-policy input
Step 3
pol_prec7
Sets VRF in which the interface operates.
vrf vrf_name
Example:
RP/0/RP0/CPU0:router(config-if)# vrf A1_MSPMSI
Step 4
Defines the IPv4 address for the interface.
{ipv4 | ipv6} address address mask
Example:
RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.7.4
Step 5
255.255.255.0
RP/0/RP0/CPU0:router(config-if)# ipv6 address
10:1::7:4/112
Configures the 802.1Q VLAN.
dot1q vlan value
Example:
RP/0/RP0/CPU0:router(config-if)# dot1q vlan 7
Step 6
Repeat steps 6 to 37 of the Configuring MVPN BIDIR.
Step 7
Enables MPLS MLDP support.mpls ldp
Example:
RP/0/RP0/CPU0:router(config-if)# mpls ldp
Step 8
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
85
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR