Cisco CRS Series - Page 96

PurposeCommand or Action
Configures the router-id.
router-id ipaddress
Example:
RP/0/RP0/CPU0:router(config-if)# router-id 1.1.1.1
Step 9
Configures MLDP.mldp
Example:
RP/0/RP0/CPU0:router(config-if)# mldp
Step 10
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
Step 11
GigabitEthernet0/3/0/2
Enters multicast routing configuration mode.multicast-routing [address-family {ipv4 | ipv6}]
Example:
RP/0/RP0/CPU0:router(config)# multicast-routing
Step 12
address-family ipv4
RP/0/RP0/CPU0:router(config)# multicast-routing
address-family ipv6
Enables IP multicast for Loopback interface.
interface type interface-path-id enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 13
interface Loopback 1 enable
Configures global multicast Cisco Non Stop
Forwarding.
nsf
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)# nsf
Step 14
Specifies the interface used to set MDT source
address.
mdt source interface-path-id
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)# mdt
Step 15
source Loopback 0
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
86
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR