PurposeCommand or Action
Enables IP multicast for interfaces.interface all enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 16
interface all enable
Sets VRF in which the interface operates.
vrf vrf_name
Example:
RP/0/RP0/CPU0:router(config-if)# vrf A1_MSPMSI
Step 17
Configures ipv4 address-family for mvpn and
enters the address family command mode.
address-family {ipv4 | ipv6}
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family ipv4
Step 18
RP/0/RP0/CPU0:router(config-bgp)# address-family ipv6
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface loopback 7
Step 19
Enables the interface.enable
Example:
RP/0/RP0/CPU0:router(config)# enable
Step 20
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
Step 21
GigabitEthernet0/3/0/1.7
Enables the interface.enable
Example:
RP/0/RP0/CPU0:router(config)# enable
Step 22
Enables BGP auto-discovery for PIM I-PMSI
core tree.
bgp auto-discovery mldp
Example:
RP/0/RP0/CPU0:router(config-bgp)# bgp auto-discovery
Step 23
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
87
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR
To Next Page
Loading...
