PurposeCommand or Action
mldp
Configures the interface used to set the MDT
source address for MVPN, using the default VRF.
mdt source interface-path-id
Example:
RP/0/RP0/CPU0:router(config-bgp)# mdt source Loopback
Step 24
0
Configures the mdt mtu value.
mdt mtu value
Example:
RP/0/RP0/CPU0:router(config-bgp)# mdt mtu 1500
Step 25
Configures the mdt partitioned mldp..mdt partitioned mldp {ipv4 | ipv6} mp2mp bidir
Example:
RP/0/RP0/CPU0:router(config-bgp)# mdt partitioned mldp
Step 26
ipv4 mp2mp bidir
Enables IP multicast for interfaces.interface all enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 27
interface all enable
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
Step 28
GigabitEthernet0/3/0/1.7
Enables the interface.enable
Example:
RP/0/RP0/CPU0:router(config)# enable
Step 29
Enables BGP auto-discovery for PIM I-PMSI
core tree.
bgp auto-discovery mldp
Example:
RP/0/RP0/CPU0:router(config-bgp)# bgp auto-discovery
Step 30
mldp
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
88
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN MLDP BIDIR
To Next Page
Loading...
