When the GoQAM boots, the boot code version and release date appear.
If BOOTP completes successfully, the IP address boot screen appears.
Note: Although it is not a typical setting, if the GoQAM is set to run in a Standalone
mode (boot mode 0), the following Standalone mode boot screen appears instead of
the “Starting GoQAM” boot screen.
The IP address boot screen remains visible for approximately 2 seconds. If no errors
occur and no downloads are attempted, the boot code starts the application code and
the following screen appears.
Next, a screen similar to the following appears.
Then, the default status screen appears.
To Next Page
Loading...
General