Introduction
This chapter describes how to install the GoQAM into a rack and where to
connect the GoQAM to the other components within the Overlay
environment. The connections used for the GoQAM vary according to its
use in your system.
Note: Refer to Technical Specifications (on page 149) for additional
technical specifications and requirements to help you install and configure
the GoQAM in your system.
In This Chapter
Installation Process Summary ............................................................. 16
Unpack and Inspect the GoQAM ....................................................... 18
Record the MAC Address .................................................................... 19
Stacking Guidelines .............................................................................. 20
Install the Modulator Into a Rack ....................................................... 24
Connect Power Sources ........................................................................ 27
Connect the DVB ASI Input Ports ...................................................... 29
Connect the 10/100BaseT Ethernet Port ............................................ 31
To Next Page
Loading...