EasyManuals Logo

Cisco GoQAM User Manual

Cisco GoQAM
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Connect the 10/100BaseT Ethernet Port
4004834 Rev D 31
Connect the 10/100BaseT Ethernet Port
Description
The GoQAM shares data with the DNCS through an ATM switch, a router, an
Ethernet hub, and an Ethernet port. An Ethernet connection enables the DNCS to
perform software downloads, provision the GoQAM, set up broadcast sessions,
monitor alarms, and check system performance.
Note: Connect the 10/100BaseT Ethernet port on the GoQAM to an Ethernet hub as
part of an Ethernet connection. Do not connect it directly to a DNCS workstation or
another PC.
Location of 10/100BaseT Ethernet Port
The following illustration shows an example of a 10/100BaseT Ethernet connection
for the IF GoQAM.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco GoQAM and is the answer not in the manual?

Cisco GoQAM Specifications

General IconGeneral
BrandCisco
ModelGoQAM
CategoryModulator
LanguageEnglish