Introduction
This chapter describes how the GoQAM functions within the Overlay
environment, explains how the GoQAM processes and outputs data, and
provides illustrations and descriptions of the front and back panel
components for both the IF and the RF versions of the GoQAM.
Important! You must be operating SR 2.5/SR 3.5 (or later) to install and
provision (configure) a GoQAM on your system.
In This Chapter
System Overview .................................................................................... 2
GoQAM Input Pairs ............................................................................... 6
Input/Output Process ............................................................................ 7
Front Panel Overview .......................................................................... 10
To Next Page
Loading...
General