Cisco GoQAM - Chapter 5 Operating the RF Modulator

4004834 Rev D 77
Introduction
This chapter contains procedures for viewing and changing GoQAM
RF settings, descriptions of screens and messages, and instructions for
performing routine maintenance.
Note: Actual screen settings may differ slightly from the examples
presented in this guide.
5 Chapter 5
Operating the RF Modulator
In This Chapter
 Understand the Boot Process .............................................................. 78
 Change the Boot Mode ......................................................................... 81
 Read the Default Status Screen ........................................................... 83
 Use the Front Panel Keys to Change Configuration Settings ......... 84
 Adjust the Frequencies of a Selected Carrier .................................... 86
 Adjust the RF Output Level of a Selected Carrier ............................ 87
 Mute the RF Output of a Selected Carrier ......................................... 88
 Change the Carrier Mode of a Selected Carrier ................................ 89
 Monitor Setup Options ........................................................................ 90
 Change an RF Carrier Frequency ....................................................... 98

Resetting the GoQAM .......................................................................... 99