16 Select the IF GoQAM input port you want to connect to the network.
17 Select the device you want to connect to the IF GoQAM in the Connect To fields
of the Connectivity tab; then, click Save. The QAM List is updated to include the
IF GoQAM.
Notes:
The fields available in the Connect To panel of the Connectivity tab vary
according to which device is selected.
See the Connectivity field descriptions, earlier in this section, for descriptions
of each field.
Refer to the Digital Network Control System Online Help for your system
release for more details about required DNCS procedures.
To Next Page
Loading...
General