Cisco GoQAM - Page 149

Alarm Conditions
4004834 Rev D 133
LCD Alarm Display
The front panel of the GoQAM displays alarm messages in the following standard
display.
Alarm at 11:51:40
Input1 loss of signal
The alarm message appears on the second line of the display. In this example, the
message indicates a loss of signal to the ASI Input, which is a major alarm condition.
Reading the Display
To display the list of active alarms, follow these steps.
1 Press OPTIONS. The Alarm Status Level screen appears.
Alarm at 11:51:40
Input1 loss of signal
Note: Each alarm description appears for approximately 1 second before
displaying the next alarm. If no alarms are active, a NO Active Alarms message
appears.
2 Press ENTER. The default screen appears.