Cisco GoQAM User Manual

Chapter 4 Provision the IF GoQAM
56 4004834 Rev D
Basic Parameters
The following table lists the Basic Parameters field descriptions.
Field Description
Headend Name Displays the name of the headend with which the
GoQAM is associated.
QAM Name Displays the name used for the GoQAM.
IP Address Displays the IP address of the Ethernet interface
through which the DNCS manages and controls
the GoQAM.
Modulation Type Allows you to specify one of the following
modulation types for each of the carriers:

ITU J.83 Annex B (6 MHz)

ITU J.83 Annex C DAVIC/DVB
(6 MHz)
Note: The default value is ITU J.83 Annex B (6
MHz).
Administrative State Specifies whether the GoQAM is active within the
system. The values are:

Offline – Default

Online – Active
MAC Address Displays the MAC address of the GoQAM
Subnet Mask Displays the IP Subnet mask assigned by the
system administrator.
Default Gateway Displays the network default gateway assigned by
the system administrator.
Ports
The following table lists the Ports field descriptions.
Field Description
Reserved TSID Range Identifies the available range of Transport
Stream IDs (TSIDs)
Input Block 1 ASI 1
Clear Transport Stream
ID
Identifies the Transport Stream ID for input
block 1 at ASI 1
Input Block 2 ASI 3
Clear Transport Stream
ID
Identifies the Transport Stream ID for input
block 2 at ASI 3

Cisco GoQAM Specifications

General

Brand	Cisco
Model	GoQAM
Category	Modulator
Language	English