Cisco GoQAM User Manual

Provision an IF GoQAM on the DNCS
4004834 Rev D 73
6 Enter the required configuration information into the blank fields on the Basic
Parameters tab in the Set Up IF GoQAM window, then go to step 9.
7 From the QAM List, highlight a GoQAM in the list, select File > Open. The Set
Up IF GoQAM window opens with the Basic Parameters tab to the forefront
displaying the Basic Parameters configuration fields.
8 Enter or change the desired information in the Basic Parameters fields, then go to
step 9.
Notes:
 See the Basic Parameters field descriptions, earlier in this section, for
descriptions of each field.
 Refer to the Digital Network Control System Online Help for your system
release for more details about required DNCS procedures.

Cisco GoQAM Specifications

General

Brand	Cisco
Model	GoQAM
Category	Modulator
Language	English