Connecting a Cable to the Output 10MHz or 1PPS Interface 44
Connecting a Cable to the GNSS Antenna Interface 44
Install and Remove Transceiver Module 45
Safety Precautions for Module Installation and Removal 45
Install and Remove SFP56, SFP28, SFP10, and SFP Modules 45
Bale Clasp SFP56, SFP28, SFP10, and SFP Module 46
Install a Bale SFP56, SFP28, SFP10, and SFP Module 47
Remove a Bale Clasp SFP56, SFP28, SFP10, and SFP Module 48
Install and Remove QSFP+, QSFP28, or QSFP-DD Transceiver Modules 49
Required Tools and Equipment 52
Install the 40-Gigabit QSFP+, 100-Gigabit QSFP28, or 200/400-Gigabit QSFP-DD Transceiver
Module 52
Attach the Optical Network Cable 53
Removing the 40-Gigabit QSFP+, 100-Gigabit QSFP28, or 200/400-Gigabit QSFP-DD Transceiver
Module 54
Connect Interface Ports 55
Connect a Fiber-Optic Port to the Network 55
Disconnect Optical Ports from the Network 55
Maintain Transceivers and Optical Cables 56
Configure the Device 57
CHAPTER 5
Create the Initial Router Configuration 57
Verify Device Installation 59
Replace Power Supply 61
CHAPTER 6
Remove the DC Power Supply Module 61
Install the DC Power Supply Module 62
Remove the AC Power Supply Module 63
Install the AC Power Supply Module 64
Appendix 65
CHAPTER 7
LEDs 65
Router LEDs 65
System Fans LED 66
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
v
Contents
To Next Page
Loading...
Need help?
General
