Cisco NCS 5000 Series Hardware Installation Guide

APPENDIX D
Cable and Port Specification
This appendix provides cable and port specifications for the Cisco NCS 5001 and 5002 Series routers.
•
Console Port, page 53
•
Supported Power Cords and Plugs, page 53
•
Jumper Power Cord, page 57
Console Port
The console port is an asynchronous RS-232 serial port with an RJ-45 connector.
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to a power distribution unit that has IEC 60320 C19 outlet receptacles. The standard power cords
have an IEC C13 connector on the end that plugs into the router. The optional jumper power cords, for use
in cabinets, have an IEC C13 connector on the end that plugs into the router and an IEC C14 connector on
the end that plugs into an IEC C13 outlet receptacle.
Only the regular power cords or jumper power cords provided with the router are supported.Note
The following table lists the power cords for the Cisco NCS 5000 Series router and provides their lengths in
feet and meters.
Hardware Installation Guide for Cisco NCS 5000 Series Routers
53

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English