CHAPTER 1
Safety Warnings
This handout lists the safety warnings necessary for handling this chassis. Before you install or service the
chassis, review these safety warnings to avoid injuring yourself or damaging the equipment.
For a complete list of translated safety warnings, see the Regulatory Compliance and Safety Information —
Cisco NCS 500 Series Routers document.
The safety warnings are grouped under the following sections:
• Standard Warning Statements, on page 1
• Safety Guidelines for Personal Safety and Equipment Protection, on page 2
• Safety with Electricity, on page 3
• Cautions and Regulatory Compliance Statements for NEBS, on page 4
• Power Supply Considerations, on page 5
• Preventing ESD Damage, on page 6
Standard Warning Statements
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
by using a special tool, lock and key, or other means of security. Statement 1017
Warning
Ultimate disposal of this product must be handled according to all national laws and regulations. Statement
1040
Warning
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
1
To Next Page
Loading...
Need help?
General
