• #12-24 pan-head screws to secure the router to the equipment rack
• Cables for connecting to the network ports (depending on the configuration)
• Ethernet hub, switch, or PC with a network interface card for connecting to the Ethernet ports
• Console terminal (an ASCII terminal or a PC running terminal emulation software) that is configured
for 115200 baud, 8 data bits, no parity, no flow control, and 1stop bit
• Console cable for connecting to the console port
• Ratcheting torque screwdriver with a Phillips head that exerts up to 30-pound force per square inch (in-lb)
or 0.02-kilograms force per square millimeter (kgf/mm2) of pressure
• Crimping tool as specified by the ground lug manufacturer
• Wire-stripping tools for stripping both 6-AWG and 14-AWG wires
• Tape measure and level
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49
Warning
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
20
Preparing for Installation
Tools and Equipment
To Next Page
Loading...
