Cisco NCS 540 - Power Status Leds; Combination of Leds; SFP SFP+ Port LED

Power Status LEDs
Table 5: Power Status LEDs
StatusColorLED Label
Sytem is powered offOffPWR
All the power supplies are on and
operating normally.
Green
Standby FPGA upgrade is in
progress (this is expected to take
about three to five minutes).
Amber
Power redundancy is lost due to a
power feed failure or an internal
power supply failure.
Red
Combination of LEDs
Table 6: Fan and Power Status LED Combination
StatusPWRBOOT
For all the conditions below, the system will not boot.
Thermal shutdown at Power UpFlashing Red
Flashing Red
MSS Ready FailureFlashing AmberFlashing Red
TAM Init FailureFlashing GreenFlashing Amber
TAM Ready FailureFlashing RedFlashing Amber
Secure JTAG FailureFlashing AmberFlashing Amber
SFP SFP+ Port LED
Table 7: SFP and SFP+ Port LEDs
StatusColorLED Label
Admin is downOffSTATUS
Link is up in 1G/10G ports.Green
Fault or Error or Link DownYellow
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
47
Appendix
Power Status LEDs