CHAPTER 4
Appendix
Certain troubleshooting aids of the Cisco NCS 540 enable you to perform these tasks that assist the
troubleshooting process:
• LEDs, on page 45
• System Specifications, on page 48
LEDs
This section lists the LEDs of the router.
Note
Router LEDs
All the data port LEDs in the Cisco N540-6Z14S-SYS-D router are at the front panel. There are five LEDs
that reflect the different statuses of the system.
Table 4: Router LED Descriptions
StatusColorLED Label
This indicates there is no DC input.Off'PS0 and PS1'
This indicates 12V output failure.
If one of the input feeds is switched
off when both the feeds are
connected, then that particular feed
shows as red.
Red
This indicates 12V output is active.Green
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
45
To Next Page
Loading...
