Figure 12: Stripping a Ground Wire
4. Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.
5. Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground
wire as shown in figure below.
Figure 13: Crimping a Ground Lug on to the Ground Wire
6. Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the
2 pan-head Phillips head screws.
7. Connect the other end of the ground wire to a suitable grounding point at your site.
Power Connection Guidelines
This section provides guidelines for connecting the router power supplies to the site power source.
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
30
Install the Cisco N540-6Z14S-SYS-D Routers
Power Connection Guidelines
To Next Page
Loading...
