7-6
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 7 Connecting the Cisco Nexus 7000 Series Switch to the Network
Connecting an I/O Module
Connecting an I/O Module
After you set up an IP address for the switch and create an out-of-band management connection for the
switch, you can connect the copper (1000BASE-T) and fiber-optic (SFP, SFP+, FET, and X2) I/O
modules to the network. Table 7-1 lists the connectors and cables that you can use with each type of I/O
module.
To Next Page
Loading...
