EasyManua.ls Logo

Cisco Nexus 7000 - Installing a Cable Management Frame

Cisco Nexus 7000
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10-76
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis
Installing a Cable Management Frame
When you install a cable management frame, you attach four cable management assemblies to the
chassis and then attach a top cover to the top two cable management assemblies and the chassis.
To install the cable management frame on the Cisco Nexus 7018 switch chassis, follow these steps:
Step 1 Open the Cable Management kit (69-1961-01) and verify that you have the following parts:
2 lower cable management assemblies (800-31343-01)
2 upper cable management assemblies (800-31342-01)
1 top cover (800-31269-01)
8 M4x8 pan-head screws (48-0398-01)
18 M4x10 flat-head screws (48-2518-01)
If the kit is not complete, contact TAC and arrange for a complete kit.
Step 2 Attach a lower cable management assembly onto the two hooks that protrude from the lower half of the
left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and loosely fasten the
assembly to the chassis with four flat-head M4x10 screws as shown in Figure 10-30.

Table of Contents

Other manuals for Cisco Nexus 7000

Related product manuals