109
A12. Mount the subwoofer grille
There is a grille in front of the subwoofer outputs.
It is composed of three parts.
1. Choose which center part to use:
• Use the one with a cut-out if you are going
to lead the cables between the table and
the video system across the floor.
• Otherwise, use the one without a cut-out.
2. Fasten each profile with two screws.
The subwoofer stands should be as close to
the grilles as possible, but not touching them.
That would cause rattling noise. You may want
to add some foam, or similar material, to avoid
metal-to-metal contact.
Subwoofer grille
1x
center part with a cut-out B12
6x
screws, Ø 4 mm (provided by installer)
Recommended color: black
3x
left and right part,
center part without a cut-out
B12
Center part
(with or without cut-out)
Left part Right part
To Next Page
Loading...