92
30. Place components on the table
30.1. Touch panels (user interfaces)
You may have one or two touch panels. Place
them on the table in a position that is convenient
for users of the system.
Connect the panels to the Ethernet switch that is
under - or close to - the table, as shown in the
wiring diagram (T4, T5).
Peripherals
nx
Microphones
nx
Touch panel (user interface)
C12
C11
30.2. Place the microphones
You may have up to six digital microphones.
Please read the Cisco Table Microphone
Pro Installation Guide (for Panorama) / Cisco
Microphone Array Installation Guide (online and
in box) and the Cisco Room Panorama Room
Preparation Guide (online) carefully to find out
where to best place the microphones.
• https://www.cisco.com/c/dam/en/us/td/
docs/telepresence/endpoint/microphone/
installation_guide/cisco-microphone-array-
installation-guide.pdf
• https://www.cisco.com/c/dam/en/us/td/
docs/telepresence/endpoint/room-series/
installation-guide/room-panorama-room-
preparation-guidelines.pdf
Connect the microphones to the Ethernet switch
that is under - or close to - the table, as shown in
the wiring diagram (M1..6).
30.3. Presentation cables
You may have up to three presentation cables.
Place them on the table where it is convenient for
the users of the system.
The presentation cables (T1, T2, T3) were pulled
through the flex tubes and connected to the
codec in step 28.
To Next Page
Loading...