Cisco Room Panorama - Mount the Loudspeakers

63
22. Mount the loudspeakers
There are six loudspeakers on each side. They are
inserted in a mounting structure that is fastened to
the risers.
Loudspeakers
2x
Speaker mounting structure (left and right)
10x
(M6x12, Torx 30)
12x
Loudspeaker
1x
Screen support profile
1. Enter a screw (M6x12, Torx 30) into the mounting
plate as shown, without tightening.
22.1. Mount the loudspeaker mounting structure
Repeat this procedure for both sides.
2. Hang the mounting structure onto the screw.
The left and right mounting structures are
not identical; they are marked with L and R,
respectively. Check that you mount them on
the correct side.
3. Add two more screws (M6x12, Torx 30). Also
tighten the first screw.
Don't tighten the
screw so much that
it becomes difficult
to hang the mounting
structure on it.
A9
C10
A1
Center
Left side
The largest hole is
toward center
A small bracket
is out to the side
Right side
Center