30
12.1. Loudspeaker cables
C6
1. Connect cable bundles A1 (left) and A2 (right) to the amplifier as shown in
the diagram.
2. Attach the cables to the hooks above the amplifier with velcro.
3. Leave ends marked S1-S6 and S7-S12 on top of the cavities:
• S1-S 6 to the left
• S7-S12 to the right
4. Hang ends marked SB1-SB4 down behind the rack cavity, and connect
them to the subwoofers.
• SB1-SB2 to the left
• SB3-SB4 to the right
SB1 SB2 SB3 SB4
5. Fasten the subwoofer cables to the bottom of the display cavities with
velcro to prevent the cables and connectors from touching the subwoofers.
Touching the subwoofers may cause rattling noise.
12.2. Power cable for the Ethernet switch in the system
C7
1. Connect the power cable (X4) to the Ethernet switch in the system.
The power socket is facing downward, so you must connect it from below.
2. Lead the cable through the hole toward the right power cavity.
Don't connect it to the socket outlet now.
3. Fasten the cable to the bottom of the display cavity with velcro to prevent
the cable from touching the subwoofers and causing rattling noise.
Make sure to leave enough slack so that it is possible to lift the switch out of
the cavity later, without disconnecting the power cable.
To Next Page
Loading...